Datasheet

Electrical Specifications
84 Datasheet, Volume 1
7.10 DC Specifications
The processor DC specifications in this section are defined at the processor
pads, unless noted otherwise. See Chapter 8 for the processor land listings and
Chapter 6 for signal definitions. Voltage and current specifications are detailed in
Table 7-4, Table 7-5, and Table 7-6.
The DC specifications for the DDR3 signals are listed in Table 7-7 Control Sideband and
Test Access Port (TAP) are listed in Table 7-8.
Table 7-4 through Table 7-6 list the DC specifications for the processor and are valid
only while meeting the thermal specifications (as specified in the Thermal / Mechanical
Specifications and Guidelines), clock frequency, and input voltages. Care should be
taken to read all notes associated with each parameter.
7.10.1 Voltage and Current Specifications
Note: Noise measurements on SENSE lands for all voltage supplies should be made with a 
20-MHz bandwidth oscilloscope.
Table 7-4. Processor Core Active and Idle Mode DC Voltage and Current Specifications
(Sheet 1 of 2)
Symbol Parameter Min Typ Max Unit Note
VID VID Range 0.2500 — 1.5200 V 1
LL
VCC
V
CC
Loadline Slope
2011D, 2011C, 2011B (processors with
77 W, 65 W, 55 W, 45 W TDP)
1.7 m 2, 4, 5
V
CC
TOB
V
CC
Tolerance Band
2011D, 2011C, 2011B (processors with
77 W, 65 W, 55 W, 45 W TDP)
PS0
PS1
PS2
±16
±13
±11.5
mV
2, 4, 5,
6
V
CC
Ripple
Ripple:
2011D, 2011C, 2011B (processors with
77 W, 65 W, 55 W, 45 W TDP)
PS0
PS1
PS2
±7
±10
-10/+25
mV
2, 4, 5,
6
LL
VCC
V
CC
Loadline Slope 2011A (processors
with 35 W TDP)
2.9 m
2, 4, 5,
7
V
CC
TOB
V
CC
Tolerance Band
2011A (processors with 35 W TDP)
PS0
PS1
PS2
±19
±19
±11.5
mV
2, 4, 5,
6, 7
V
CC
Ripple
Ripple:
2011A (processors with 35 W TDP)
PS0
PS1
PS2
±10
±10
-10/+25
mV
2, 4, 5,
6, 7
V
CC,BOOT
Default V
CC
voltage for initial power up — 0 — V
I
CC
2011D I
CC
(processors with 77 W, TDP) — — 112 A 3
I
CC
2011C I
CC
(processors with 55 W TDP) — — 75 A 3