User Manual
Table Of Contents
- Overview
- Setting Up the Gateway on a Network
- Changing the Gateway Settings
- Using the Advanced Feature Set
- Accessing advanced features
- Changing your gateway password
- Changing your advanced wireless settings
- Setting your transfer rate
- Setting your operating channel
- Using system tools
- Establishing routing protocols
- Refining DHCP server addressing
- Assigning virtual server settings
- Using access control features
- Changing your gateway IP address
- IP addressing in network adapters
- Universal Plug and Play
- Troubleshooting
- Glossary
- Glossary
- 802.11b
- Ad Hoc Mode
- Adapter
- Access Point (AP)
- ASCII characters
- DHCP
- Driver (Device Driver)
- DNS
- Encryption
- Ethernet
- Ethernet address (MAC address)
- Firewall
- Gateway
- Hexadecimal
- Hub
- Infrastructure Mode
- IEEE
- ISP
- LAN
- Mbps
- NAT
- Peer-to-Peer Mode
- Profiles (Network Profiles)
- Protocols (Network Protocols)
- Resources (Network resources)
- Roaming
- SSID
- Subnet
- Subnet mask
- Switch
- TCP/IP
- UPnP
- USB
- VPN
- Glossary
- Specifications
- Regulatory Compliance Statements
- Index
Chapter 3 – Changing the Gateway Settings
24
Opening the gateway configuration software
The configuration software for the gateway resides inside
the gateway, not on the Internet.
Step-by-step 1 Type the following Internet address into your Web
browser: http://192.168.0.10.
or
Go to Start > Programs > Intel AnyPoint > Intel
Wireless Gateway 1210 > Network Setup, and then
click Yes when asked if you want to change the
gateway settings.
The following appears.
2 Enter your user name and password and then click
OK.
The following appears.
user_guide_rg1210.book Page 24 Monday, April 22, 2002 2:20 PM