User's Guide

28
Chapter 4: Operating the Device
4.4.6.3 Setting the 1D/2D Barcode Scanner Symbologies
The barcode scanner is shipped with default settings shown below. If the default setting suits the usage
requirement, setting symbologies is not necessary.
Symbologies Default Settings:
Symbologies
Default
Linear
UPC-A
Enable
UPC-E
Enable
EAN/JAN-8
Enable
EAN/JAN-13
Enable
UPC-E1
Disable
UPC-A/EAN-13 Extended Coupon Code
Disable
GS1 DataBar Omni-Directinal
Enable
GS1 DataBar Limited
Enable
GS1 DataBar Expanded
Enable
Code 39
Enable
Code 128
Enable
ISBT 128
Disable
GS1-128
Enable
Interleaved 2 of 5
Enable
Matrix 2 of 5
Disable
NEC 2/5
Enable
IATA 2/5
Disable
Code 2/5
Disable
Codabar
Enable
Code 93
Enable
Code 11
Disable
MSI
Disable
Telepen
Disable
Trioptic Code
Disable
Postal Code
Disable
Planet Code
Disable
Korea Psot
Disable
China Post
Disable
Australian Post
Disable
2D
Data Matrix
Enable
PDF 417
Enable
Micro PDF 417
Enable
Codablock A
Disable
Codablock F
Disable
Maxicode
Disable
QR Code
Enable
Aztec
Enable
Composite Code
Disable
Han Xin
Disable
Changing default setting of symbologies or the advanced setting
There are two methods tochange the default setting of symbologies or other advanced setting:
Method (1). Click on the Symbologies on the top, then you can change the
symbology to the default setting or make advanced setting by its category.After setting, click on the
“Save to Device” on the side bar.
Method (2). Click on the reset to default button on the side as shown blow: