Datasheet

Processor Configuration Registers
298 Datasheet, Volume 2
2.19.2 MEM_TRML_THRESHOLDS_CONFIG—Memory
Thermal Thresholds Configuration Register
This register is used to describe the thresholds of the memory thermal management in
the memory controller. The warm threshold defines when self-refresh is at double data
rate. Throttling can also be applied at this threshold based on the configuration in the
memory controller. The hot threshold defines the threshold at which severe thermal
throttling will occur. Self Refresh is also at double rate during a hot condition.
B/D/F/Type: 0/0/0/MCHBAR PCU
Address Offset: 5888–588Bh
Reset Value: 00E4DAD0h
Access: RW
Size: 32 bits
BIOS Optimal Default 00EDAD0h
Bit Access
Reset
Value
RST/
PWR
Description
31:16 RO 0h Reserved (RSVD)
15 RW 1b Uncore
Hot Threshold Enable (HOT_THRESHOLD_ENABLE)
This bit must be set to allow the hot threshold.
14:8 RW 1010101b Uncore
Hot Threshold (HOT_THRESHOLD)
This threshold defines what is the acceptable temperature
limitation. When this threshold is crossed, severe throttling takes
place. The self refresh is also at double rate.
7RW 1bUncore
Warm Threshold Enable (WARM_THRESHOLD_ENABLE)
This bit must be set to allow the warm threshold.
6:0 RW 1010000b Uncore
Warm Threshold (WARM_THRESHOLD)
The warm temperature threshold defines when the self refresh is
at double rate. Throttling can also be applied at this threshold
based on the configuration in the memory controller.