User's Guide
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Accessories
- Chapter 5. Secure your computer and information
- Chapter 6. Configure advanced settings
- Chapter 7. CRU replacement
- Chapter 8. Help and support
- Appendix A. Important safety information
- Appendix B. Accessibility and ergonomic information
- Appendix C. Supplemental information about the Ubuntu operating system
- Appendix D. Compliance information
- Appendix E. Notices and trademarks
9. Turn over the computer. Connect the ac power adapter and all disconnected cables to the computer.
Note: If you install a new hybrid solid-state drive (with Intel Optane memory), enable Intel Optane memory by
doing the following:
1. Restart your computer. When the logo screen is displayed, immediately press F1 to enter the UEFI BIOS
menu.
2. Select Config ➙ Storage ➙ Controller mode. Ensure that RST mode is selected.
3. Go to
https://support.lenovo.com. Download and install the Intel Rapid Storage Technology (iRST)
Console with Device Driver on your computer.
4. Run the iRST Console with Device Driver.
5. Click Intel Optane Memory and then follow the instructions on the screen to enable it.
Pen charger (for X1 Yoga only)
Prerequisite
Before you start, read Appendix A “Important safety information” on page 67 and print the following
instructions.
Replacement procedure
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 53.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close and computer display and turn over the computer.
4. Remove the base cover assembly. See “Base cover assembly” on page 54.
5. Remove the screw that secures the pen charger
1 and detach the connector 2 . Then, remove the pen
charger
3 .
Chapter 7. CRU replacement 59