Intel Wireless 7260 Family Regulatory Markings

Intel Corporation – Mobile Communication Group
Page 7 of 13 Aug 26, 2013
interface is part of the Intel® PROSet/Wireless WiFi Connection Utility Software. Operational restrictions for
Equivalent Isotropic Radiated Power (EIRP) are provided by the system manufacturer. Any deviation from the
permissible power and frequency settings for the country of use is an infringement of national law and may be
punished as such.
FCC Radio Frequency Interference Requirements
This wireless adapter is restricted to indoor use due to its operation in the 5.15 to 5.25 and 5.470 to 5.75GHz
frequency ranges. FCC requires this wireless adapter to be used indoors for the frequency ranges 5.15 to
5.25GHz and 5.470 to 5.75GHz to reduce the potential for harmful interference to co-channel mobile satellite
systems. No configuration controls are provided for Intel® wireless adapters allowing any change in the
frequency of operations outside the FCC grant of authorization for U.S. operation according to Part 15.407 of
the FCC rules:
• This wireless adapter is intended for OEM integrators only.
• This wireless adapter cannot be co-located with any other transmitter unless approved by the FCC based
upon FCC Knowledge Database publication number 616217 D03 (Supplement) when there are multiple
radios installed in a host device, RF exposure transmitting assessment shall be performed to determine
the necessary application and test requirements. Certain criteria can be used in determine the
requirement for simultaneous SAR evaluation and whether Class I or Class II permissive change may
apply. OEM integrators must consult the actual FCC KDB 616217 Supplement document for details
USA—Federal Communications Commission (FCC)
This wireless adapter complies with Part 15 of the FCC Rules. Operation of the device is subject to the
following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired operation.
• The requirements described within this document are provided to OEM’s and system integrators
installing the wireless adapter in host platforms. Strict adherence to these requirements is necessary to
meet the conditions of compliance with FCC and Industry Canada rules for RF exposure. When all
requirements described herein are fulfilled the wireless adapter may be installed in host platforms with
no further RF exposure restrictions when integrating. If any of the requirements herein are not fulfilled
then additional testing and FCC/IC Permissive Changes may be required with the specific host platform
and/or antennas for compliance.
Antenna Type and Gains
• Only antennas of the same type and with equal or less gains as shown below may be used with the
Intel® wireless adapters. Other types of antennas and/or higher gain antennas may require additional
authorization for operation.
Table-1: Worst Case Antenna Gain Definition