Datasheet

Processor Configuration Registers
178 Datasheet, Volume 2
7:6 RO 00b Uncore
Reserved for Attention Indicator Control (AIC)
If an Attention Indicator is implemented, writes to this field set the
Attention Indicator to the written state. Reads of this field must
reflect the value from the latest write, even if the corresponding
hot-plug command is not complete, unless software issues a write
without waiting for the previous command to complete in which
case the read value is undefined. If the indicator is electrically
controlled by chassis, the indicator is controlled directly by the
downstream port through implementation specific mechanisms.
00 = Reserved
01 = On
10 = Blink
11 = Off
If the Attention Indicator Present bit in the Slot Capabilities
register is 0b, this field is permitted to be read only with a value of
00b.
5RO 0bUncore
Reserved for Hot-plug Interrupt Enable (HPIE)
When set to 1b, this bit enables generation of an interrupt on
enabled hot-plug events. The Reset Value of this field is 0b. If the
Hot Plug Capable field in the Slot Capabilities register is set to 0b,
this bit is permitted to be read only with a value of 0b.
4RO 0bUncore
Reserved for Command Completed Interrupt Enable (CCI)
If Command Completed notification is supported (as indicated by
No Command Completed Support field of Slot Capabilities
Register), when set to 1b, this bit enables software notification
when a hot-plug command is completed by the Hot-Plug Controller.
If Command Completed notification is not supported, this bit must
be hardwired to 0b.
3RO 0bUncore
Presence Detect Changed Enable (PDCE)
When set to 1b, this bit enables software notification on a presence
detect changed event.
2RO 0bUncore
Reserved for MRL Sensor Changed Enable (MSCE)
When set to 1b, this bit enables software notification on a MRL
sensor changed event.
If the MRL Sensor Present field in the Slot Capabilities register is
set to 0b, this bit is permitted to be read only with a value of 0b.
1RO 0bUncore
Reserved for Power Fault Detected Enable (PFDE)
When set to 1b, this bit enables software notification on a power
fault event.
If Power Fault detection is not supported, this bit is permitted to be
read only with a value of 0b.
0RO 0bUncore
Reserved for Attention Button Pressed Enable (ABPE)
When set to 1b, this bit enables software notification on an
attention button pressed event.
B/D/F/Type: 0/6/0/PCI
Address Offset: B8–B9h
Reset Value: 0000h
Access: RO,
Size: 16 bits
BIOS Optimal Default 0h
Bit Attr
Reset
Value
RST/
PWR
Description