User Manual

Chapter 4. Configuring the Intel® Wireless Gateway
Intel® Wireless Gateway User's Guide 29
4.2 Intel® Wireless Gateway Manager
The Intel® Wireless Gateway Manager is an alternative solution for configuring the Intel®
Wireless Gateway. This software must be installed on one of the clients in the network.
Information regarding the Intel® Wireless Gateway Manager can be found on the Intel support
Website, http://www.intel.com/support
.
4.3 Using Telnet
The Intel® Wireless Gateway can be configured via a Telnet session. To configure the access
point with Telnet, open a command prompt. If you are using the default IP address for the access
point, type
telnet 192.0.2.1 . Otherwise, use the IP address that has been assigned to the
access point,
telnet <IP Address> .
When prompted for a password, enter the.password that has been assigned to the Intel® Wireless
Gateway. If the password has not been changed, use the default password,
Intel . Press Enter ,
and a user interface should appear.
4.4 Using a Console Serial Port
The Intel® Wireless Gateway may be configured via a console serial port. To use this option,
connect a null-wired serial cable to the console port on the back of the access point and to the
serial port of a computer. Use Microsoft HyperTerminal or another similar terminal program to
access the Intel® Wireless Gateway. Enter the communication parameters as
115200,N,8,1 .
When prompted for a password, enter the.password that has been assigned to the Intel® Wireless
Gateway. If the password has not been changed, use the default password,
Intel . Press Enter ,
and a user interface should appear.