User Manual

Chapter 4. Configuring the Intel® Wireless Gateway
Intel® Wireless Gateway User's Guide 21
If DHCP is disabled on the Intel® Wireless Gateway and there is no other DHCP Server in the
network, you must manually assign IP addresses to each wired and wireless client.
If DHCP is disabled on the Intel® Wireless Gateway and there is a DHCP Server in the network,
the Intel® Wireless Gateway and other computers in the network can be configured as DHCP
clients. They are automatically assigned IP addresses by the DHCP Server.
From the DHCP Server Settings page, use the
Enable DHCP Server Functions checkbox to
indicate whether or not the Intel® Wireless Gateway should act as a DHCP server.
The Enable DHCP Server Functions box is already checked if the device’s function was set to
Enable as a Wireless Access Point and Gateway from the Function Settings page in the Setup
Wizard.
The IP Address Pool Range section provides a means of controlling a low and high value for the
IP addresses on a network. Use the indicated fields to define the range of addresses for the
network.
Image 4. DHCP Server Settings