User's Manual




RevisionHistory
Rev.1.0,September‐2012 36/60
HardwareUserGuide,DocumentNumber:N/A
7. Findthecom‐portinwhichUEisconnectedusing
comtesttool.Runthecommandcomtest–l.Itwilllist
theports.Carefullyevaluatetheportfortracingand 
portforcontrol.
8.
TocheckwhetherPCisconnectedtoUEproperly,try
connectingthecontrolportwiththeterminal
emulatorandsend“AT”command,Iftheresponseis
OK,UEisconnectedsuccessfully.Thiscanbedonevia
ATConsoleinSystemTraceTool.
9.
SendthebelowATcommands:
a.
Enabletracingatallsources:at+trace=1;
b.
RoutetracesthroughUE's"OCT‐Block",which
createstheISTPformat:at+xsio=3;
c.
Selectthetracesfromspecificsources,use
at+xystracecommand.Forexample,toconfigure