User's Manual




RevisionHistory
Rev.1.0,September‐2012 34/60
HardwareUserGuide,DocumentNumber:N/A
2.3.1.2 BoardConfigurationandrequiredATCommands
 Resettheboardinawaythatisbootingfromtheflash

Enabletracingusing:at+xsystrace=0,"lte_l1_sw=4"

Resettheboardagaininawaythatisbootingfrom
theflash

Nowtheinitializationatcommandstoswitchto
ServiceMode(thatisthemodetouseRCTTH)canbe
sentifneeded:

ARMforInc2.8:‘at@ecal:’’at@ecal_init():’

ARMforInc3.0:‘at@ephy:smon()’

Note:PleasecheckwiththeprovideroftheARM
imagewhichcommandsarevalidfortheactual
build!!!
 TheATcommandsbelowaremandatorytoenabletracing:
a. Enabletracingatallsources:at+trace=1;