User's Manual




RevisionHistory
Rev.1.0,September‐2012 33/60
HardwareUserGuide,DocumentNumber:N/A
2.3 SystemTraceBox
2.3.1 SetupandConfiguration
2.3.1.1 EnteringATCommands
TheATcommandsmentionedbelowmustbesenttotheCOM
portthatcorrespondstothe

IntelMobile(USB3)COMportincasetheecm200
driverisusedor

totheCOMportthatcorrespondstotheComneon
HighSpeedModem,seeError!Referencesourcenot
found..
TheCOMportthatcorrespondstotheUSIF‐1USBport,seeError!TheCOMportthatcorrespondstotheUSIF‐1USBport,seeError!
Referencesourcenotfound.mayalso
work.
Theudp2ATservercanbeusedtoenterlocalATcommandsfromTheudp2ATservercanbeusedtoenterlocalATcommandsfrom
remotelocations,seeSubsec.Error!Referencesourcenotfound..
