User's Manual




RevisionHistory
Rev.1.0,September‐2012 21/60
HardwareUserGuide,DocumentNumber:N/A

2.1.2.2 StaticIPAddressConfiguration
 ThegivenexampleIPnumberatFigure12isfora
simplifiedtestanddebugsetup,seeError!Reference
sourcenotfound.,wheretheoctaveorjavaclient
runsontheWinPCthatalsocarriesallnecessaryWin
driversandisconnectedtotheDUT.Theecm200
driverruns
inasubnetthatisonlyvisiblefromthis PC.

Thecompletesetup,seeError!Referencesourcenot
found.,consistsoftestPCsthatwereprovided
togetherwithrecommendedIPsettingsforthe
ecm200driver.Thestaticroutesettingswereset
typicallyITsystemwide.

IncasetwoPCswereusedtorunthetests,atestPC IncasetwoPCswereusedtorunthetests,atestPC
withthedriversandadesktopPCthatcarriesthe
OctaveortheJavaclientastaticroutemustbesetat