User's Manual
RevisionHistory
Rev.1.2,Feb.2015 4/44
HardwareUser
Guide,DocumentNumber:N/A
Figures
Figure 1. Location of the Prolific serial to USB driver, the Flash USB driver and the
FTDI diver within the flash tool folder.................................................................................8
Figure 2. Use the already installed driver................................................................................10
Figure 3. Install the driver again.................................................................................................10
Figure 4. The network modem and four COM ports are now appearing at the
device manager..........................................................................................................................11
Figure 5. Open the network connections dialog. Win XP :
Start:Settings:NetworkConnectios. A new network device did pop up. It is not
yet connected..............................................................................................................................12
Figure 6. On Win7: Select “Start:Control Panel:Network and Sharing Center”
followed by “Change adapter settings”............................................................................12
Figure 7. Open the properties dialog of the new network device (right click)..........12
Figure 8. Select the configuration dialog.................................................................................13
Figure 9. Set the client offset to 1 and press “OK”..............................................................14
Figure 10. Press “OK” to save these settings. Otherwise these settings get lost....14
Figure 11. Open the Internet Protocol TCP/IP settings......................................................16
Figure 12. Set the static Network IP and press OK.............................................................17
Figure 13. To close the properties dialog and save the settings press “OK”.............17
Figure 14. Congratulations. Your ecm200 driver and its IP connection are now
properly configured...................................................................................................................18
Figure 15. Use the already installed driver.............................................................................19
Figure 16. Install the driver..........................................................................................................19
Figure 17. Comneon suspend and six COM ports are now appearing at the device
manager.........................................................................................................................................20
Figure 18. USIF1 Device Manager Prolific USB-to-Serial COM Port...............................21
Figure 19. Putty configuration......................................................................................................22
Figure 20. CMW 500.........................................................................................................................28