User's Manual




RevisionHistory
Rev. 1.2 ,Feb.2015 18/44
HardwareUser
Guide ,DocumentNumber:N/A

Figure14.Congratulations.Yourecm200driveranditsIPconnectionarenowproperly
configured.
 Ifdesireditisnowalsopossibletorenamethenetworkdevicefrom“Wireless
Connection2”tosomethingmoreconveniente.g.ecm200+IPaddress.
2.1.3 ComneonHighSpeedModemDriver
 Taketherecommendeddriver,
 \\musdsara001.imu.imc.local\SW_builds\xmm6360\tools\usb_drive
rs
See also SMS02534274: ‐Pleaseuse3.46versionandnot
WMC_comneon2_3.55.0,seeSubsec.2.1.1,(folder
Comneon_High_Speed_Modem_Driver)andfollowtheinstructionsfromthe
installationwizard.
 Now connect the cable to the USB-HS connector.
 Win XP asks now it’s typical questions again and gets the common answers, see
below. Win 7 does not ask and loads the driver automatically.