User's Manual
with the product. Any other installation or use will violate FCC Part 15
regulations.
Safety Approval Considerations
This device has been safety approved as a component and is for use only in complete equipment
where the acceptability of the combination is determined by the appropriate safety agencies.
When installed, consideration must be given to the following:
It must be installed into a compliant host device meeting the requirement of UL/EN/IEC
60950-1 2nd edition including the general provisions of enclosure design 1.6.2 and
specifically paragraph 1.2.6.2 (Fire Enclosure).
The device shall be supplied by a SELV source when installed in the end-use equipment.
A heating test shall be considered in the end-use product for meeting the requirement of
UL/EN/IEC 60950-1 2nd edition.
Low Halogen
Applies only to brominated and chlorinated flame retardants (BFRs/CFRs) and PVC in the final
product. Intel components as well as purchased components on the finished assembly meet JS-
709 requirements, and the PCB / substrate meet IEC 61249-2-21 requirements. The replacement
of halogenated flame retardants and/or PVC may not be better for the environment.
Canada – Industry Canada (IC)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil se conforme aux normes Canada d'Industrie de RSS permis-exempt. L'utilisation est
assujetti aux deux conditions suivantes: (1) cet appareil ne peut pas causer d'interférences, et (2)
cet appareil doit accepter des interférences , y compris des interférences qui peuvent causer
desopérations non désirées de l'appareil.
Caution: When using IEEE 802.11a wireless LAN, this product is restricted to indoor use due to
its operation in the 5.15- to 5.25-GHz frequency range. Industry Canada requires this product to
be used indoors for the frequency range of 5.15GHz to 5.25GHz to reduce the potential for
harmful interference to co-channel mobile satellite systems. High power radar is allocated as the
primary user of the 5.25- to 5.35-GHz and 5.65 to 5.85-GHz bands. These radar stations can