User's Manual

to your local C:\ drive by default. Accept the default save location or click Browse to choose another
location on your computer.
Next, you can connect an enrollee (computer) to the network using the registrar.
Connect an Enrollee to a WiFi Network or Access Point
Perform these steps to connect an enrollee to the network you just created. This assumes that the registrar
computer is running the WiFi connection utility.
NOTE: To achieve transfer rates greater than 54 Mbps on 802.11n connections, WPA2-AES security must
be selected. No security (None) can be selected to enable network setup and troubleshooting.
1. At the enrollee you want to connect the network, a message tells you that one or more access points
with Wi-Fi Protected Setup capability is within range of your wireless computer. Click on this
message. (Or, you can select the network from the WiFi Networks list in the WiFi connection utility
main window.)
2. The WiFi Protected Setup Wizard start up page opens. Use the Available Networks list to select
the network that you want to connect to (in this example it is MyWPS). Then click Next.