User's Manual

(Main/Aux) Peak Gain
in dBi*
Peak Gain
in dBi*
Peak Gain
in dBi*
Peak Gain
in dBi*
Peak Gain
in dBi*
PIFA Main 3.24 3.47 3.73 4.77 4.97
Aux
MIMO
*All antenna gains include cable loss.
Antenna Placement Within the Host System
To ensure RF exposure compliance, the antenna(s) used with the Intel® wireless adapters must be installed in the
host system to provide a minimum separation distance from all persons, in all operating modes and orientations of
the host system, with strict adherence to the table below. The antenna separation distance applies to both
horizontal and vertical orientation of the antenna when installed in the host system.
Wireless Adapter Minimum required antenna-to-user
separation distance
Intel® Centrino® Wireless-N 100 9 mm
Intel® Centrino® Wireless-N 105 9 mm
Intel® Centrino® Wireless-N 130 8 mm
Intel® Centrino® Wireless-N 135 9 mm
Intel® WiFi Link 1000* 20 mm
Intel® Centrino® Wireless-N 1030 8 mm
Intel® Centrino® Wireless-N 2200 9 mm
Intel® Centrino® Wireless-N 2230 9 mm
Intel® Centrino® Advanced-N 6200* 20 mm
Intel® Centrino® Advanced-N 6205 12 mm
Intel® Centrino® Advanced-N 6230 12 mm
Intel® Centrino® Advanced-N 6235 12 mm
Intel® Centrino® Ultimate-N 6300 13 mm
* This wireless adapter may be installed in mobile devices only
(requires > 20 cm antenna separation from the body of user).
Simultaneous Transmission of Intel® Wireless Adapters with Other Integrated or Plug-In Transmitters
Based upon FCC Knowledge Database publication number 616217 D03 Supplement
https://fjallfoss.fcc.gov/kdb/GetAttachment.html?id=30257
, when there are multiple transmitting devices installed
in a host device, an RF exposure transmitting assessment shall be performed to determine the necessary
application and test requirements. OEM integrators must identify all possible combinations of simultaneous
transmission configurations for all transmitters and antennas installed in the host system. This includes
transmitters installed in the host as mobile devices (>20 cm separation from user) and portable devices (<20 cm
separation from user). OEM integrators should consult the actual FCC KDB 616217 D03 Supplement document for
all details in making this assessment to determine if any additional requirements for testing or FCC approval is
necessary.
Information To Be Supplied to the End User by the OEM or Integrator
The following regulatory and safety notices must be published in documentation supplied to the end user of the
product or system incorporating the Intel® wireless adapter, in compliance with local regulations. Host system
must be labeled with "Contains FCC ID: XXXXXXXX", FCC ID displayed on label.
The wireless adapter must be installed and used in strict accordance with the manufacturer's instructions as
described in the user documentation that comes with the product. For country-specific approvals, see Radio
cm
cm