User's Manual

Maple Peak Setup
2 Maple Peak Setup
The Maple Peak setup consists of the following components:
• One WiGig link that contains Maple Peak on the NB side and Maple Peak SNK on the dock side.
Note: Note that each MpL-M card (the baseband) is connected to MpL-R card (the 60 Ghz radio)
• A PC that serves as the NB host
WiGig connectivity can be performed in two modes:
• Test mode – setup can perform a pre-defined set of traffic according to the accompanying OEM
Tool application.
• Operational mode – real WiGig pairing, with WDE and WSE PALs.
2.1 Operational mode
2.1.1 IF setup description (dock installer only)
Figure 2-1 IF setup
Table 2-1 IF setup description
Description
Table-top IF-to-IF (coaxial based) non-over-the-air reference-design setup for
client side
Maple Peak HW
M.2 ES'; RFEM ES'
Capabilities
WSE; WDE
Wired / OTA
Wired (coaxial cable)*
Intel
®
Maple Peak July 2014
User Guide Document Number: 537178-2.1
8 Intel Confidential