User's Manual

Software Install
Select Stacks
8. Select stacks to install:
• Operational stack – Select
• Debug stack – Select
• NDIS driver – Don't Select
9. Click Install.
The installer installs and configures the card based on user specifications.
This process takes up to two minutes; a verification popup appears when successfully
completed.
Note: If you want to change any selection in the installation, such as hardware type or setup
type, you will need to uninstall the SW package (Windows->Control Panel->Uninstall a
program) and install the application again.
3.2.3 Burning the flash using DFB tool
The DFB tool can be found at C:/Program Files/Intel/WiGig/DFB/WiGigDockFlashBurner.exe.
Run the DFB application on the host to burn the dock Flash with the relevant FW version.
Run the application from the command line with the relevant parameters:
• For factory slot:
WiGigDockFlashBurner.exe --factory --package
"C:\Program Files\Intel\WiGig\Drivers\Dock_Image_Production.pack"
• For current slot:
WiGigDockFlashBurner.exe --package
"C:\Program Files\Intel\WiGig\Drivers\Dock_Image_Production.pack"
Note: Burn both the factory slot and the current slot.
• See DFB document (Reference #4) for detailed instructions on how to use the DFB tool.
§
July 2014 Intel
®
Maple Peak
Document Number: 537178-2.1 User Guide
Intel Confidential 15