User's Manual

ManualsBrandsIntel Mobile Communications ManualsElectronicsWiGig Docking Module

Table Of Contents

1 Introduction
2 Maple Peak Setup
- 2.1 Operational mode
  - 2.1.1 IF setup description (dock installer only)
  - 2.1.2 RF setup description
- 2.2 Test mode (OEM tool setup environment)
3 Software Install
- 3.1 NB side installation
- 3.2 Dock side installation
4 WiGig Application User Manual
5 WiGig Recording Tool (WiGRT)
- 5.1 WiGRT installation
- 5.2 How to use WiGRT
  - 5.2.1 Generate Report menu
  - 5.2.2 Settings menu
    - 5.2.2.1 XML settings

Software Install

Select Hardware Type

Maple Peak can communicate with another device via:

• IF (Intermediate Frequency): a cable is required between the card (XFL connector) and

another device.

• RF: the M.2 card is connected to the RFEM.

6. Select the relevant mode.

Choose IF mode if you have no RFEM connected to the M.2. This has no effect on the hostless

setup; it is in RF mode after disconnecting the PCIe.

Select Number of Antennas

7. Select one antenna.

Intel

®

Maple Peak July 2014

User Guide Document Number: 537178-2.1

14 Intel Confidential