User's Manual
Table Of Contents
- Intel(R) PROSet/Wireless WiFi Connection Utility User's Guide
- Use the Intel(R) PROSet/Wireless WiFi Connection Utility
- Main Window
- Taskbar Icon and Menu Commands
- Connection Status Icons
- Wireless Network Overview
- Connect to a WiFi Network
- Network Connection Details
- Network Properties
- Personal Security
- Use Wi-Fi Protected Setup*
- Turn Wireless Radio On or Off
- Application Settings (Tools menu)
- Administrator Tool
- Adapter Settings
- Advanced Statistics (Advanced menu)
- Exclude List Management
- Profile Management
- Profile Wizard General Settings
- Security Overview
- Enterprise Security
- Application Settings (Administrator Tool)
- Administrator Password
- Advanced Settings
- Set up Profile Security
- Configure Profiles for Network (Infrastructure) Operating Mode
- Administrator Tool Settings
- Intel(R) Wireless Troubleshooter (Tools menu)
- Manual Diagnostics Tool
- Wireless Event Viewer
- Regulatory Information
- Specifications
- Customer Support
- Warranty Information
- Glossary
operated in countries other than those of designated use. As a user of these products, you
are responsible for ensuring that the products are used only in the countries for which they
were intended and for verifying that they are configured with the correct selection of
frequency and channel for the country of use. Any deviation from permissible settings and
restrictions in the country of use could be an infringement of national law and may be
punished as such.
FCC Radio Frequency Interference Requirements
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency
range. FCC requires this product to be used indoors for the frequency range 5.15 to 5.25
GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85
GHz bands. These radar stations can cause interference with and /or damage this device.
● This device is intended for OEM integrators only.
● This device cannot be co-located with any other transmitter unless approved by the
FCC.
USA—Federal Communications Commission (FCC)
This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the
following two conditions:
● This device may not cause harmful interference.
● This device must accept any interference that may cause undesired operation.
NOTE: The radiated output power of the adapter is far below the FCC radio
frequency exposure limits. Nevertheless, the adapter should be used in such a
manner that the potential for human contact during normal operation is
minimized. To avoid the possibility of exceeding the FCC radio frequency
exposure limits, you should keep a distance of at least 20 cm between you (or
any other person in the vicinity) and the antenna that is built into the
computer. Details of the authorized configurations can be found at
http://www.
fcc.gov/oet/ea/ by entering the FCC ID number on the device.
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If the equipment is not
installed and used in accordance with the instructions, the equipment may cause harmful
interference to radio communications. There is no guarantee, however, that such
interference will not occur in a particular installation. If this equipment does cause harmful