User's Manual
Table Of Contents
- Intel(R) PROSet/Wireless WiFi Connection Utility User's Guide
- Use the Intel(R) PROSet/Wireless WiFi Connection Utility
- Main Window
- Taskbar Icon and Menu Commands
- Connection Status Icons
- Wireless Network Overview
- Connect to a WiFi Network
- Network Connection Details
- Network Properties
- Personal Security
- Use Wi-Fi Protected Setup*
- Turn Wireless Radio On or Off
- Application Settings (Tools menu)
- Administrator Tool
- Adapter Settings
- Advanced Statistics (Advanced menu)
- Exclude List Management
- Profile Management
- Profile Wizard General Settings
- Security Overview
- Enterprise Security
- Application Settings (Administrator Tool)
- Administrator Password
- Advanced Settings
- Set up Profile Security
- Configure Profiles for Network (Infrastructure) Operating Mode
- Administrator Tool Settings
- Intel(R) Wireless Troubleshooter (Tools menu)
- Manual Diagnostics Tool
- Wireless Event Viewer
- Regulatory Information
- Specifications
- Customer Support
- Warranty Information
- Glossary
to your local C:\ drive by default. Accept the default save location or click Browse to choose another
location on your computer.
Next, you can connect an enrollee (computer) to the network using the registrar.
Connect an Enrollee to a WiFi Network or Access Point
Perform these steps to connect an enrollee to the network you just created. This assumes that the registrar
computer is running the WiFi connection utility.
NOTE: To achieve transfer rates greater than 54 Mbps on 802.11n connections, WPA2-AES security must
be selected. No security (None) can be selected to enable network setup and troubleshooting.
1. At the enrollee you want to connect the network, a message tells you that one or more access points
with Wi-Fi Protected Setup capability is within range of your wireless computer. Click on this
message. (Or, you can select the network from the WiFi Networks list in the WiFi connection utility
main window.)
2. The WiFi Protected Setup Wizard start up page opens. Use the Available Networks list to select
the network that you want to connect to (in this example it is MyWPS). Then click Next.