User's Manual

ManualsBrandsIntel Mobile Communications ManualsElectronicsIntel Centrino Wireless-N 1030

WMM Disabled

Fat Channel

Intolerant

This setting communicates to surrounding networks that this WiFi

adapter is not tolerant of 40MHz channels in the 2.4GHz band. The

default setting is for this to be turned off (disabled), so that the

adapter does not send this notification.

NOTE: This setting does not apply to the following adapters:

Intel® Wireless WiFi Link 4965AG_

Intel® PRO/Wireless 3945ABG Network Connection

Mixed mode

protection

Use to avoid data collisions in a mixed 802.11b and 802.11g

environment. Request to Send/Clear to Send (RTS/CTS) should be

used in an environment where clients may not hear each other. CTS-

to-self can be used to gain more throughput in an environment where

clients are in close proximity and can hear each other.

Power

Management

Lets you select a balance between power consumption and WiFi

adapter performance. The WiFi adapter power settings slider sets a

balance between the computer's power source and the battery.

Use default value: (Default) Power settings are based on the

computer's power source.

Manual: Adjust the slider for the desired setting. Use the

lowest setting for maximum battery life. Use the highest setting

for maximum performance.

NOTE: Power consumption savings vary based on Network

(Infrastructure) settings.

Roaming

Aggressiveness

This setting lets you define how aggressively your wireless client

roams to improve connection to an access point.

Default: Balanced setting between not roaming and

performance.

Lowest: Your wireless client will not roam. Only significant link

quality degradation causes it to roam to another access point.

Highest: Your wireless client continuously tracks the link

quality. If any degradation occurs, it tries to find and roam to a

better access point.

Throughput

Enhancement

Changes the value of the Packet Burst Control.

Enable: Select to enable throughput enhancement.

Disable: (Default) Select to disable throughput enhancement.

Transmit Power

Default Setting: Highest power setting.

Lowest: Minimum Coverage: Set the adapter to the lowest transmit