Instruction manual

7
6
Turning to select channels 1-16.
.Power/Volume knob
Turn clockwise to turn on the radio, keep turning to adjust the
volume.To turn off the radio, just turn the knob anticlockwise till a
sound of “ Ka-Da” is produced.
.PTT (PUSH-TO-TALK) key
Press the PTT key and talk towards the MIC to send the voice to the
recipient.
.Side key 1 (programmable key)
.Side key 2 (programmable key)
.Top key (programmable key)
.Speaker/MIC connector
Connecting external speaker and MIC.
4. Basic Operation
. Startup:
Turn the Power/Volume knob clockwise to
turn on the radio. If the dealer has set the
prompt sound, a sound of “ Bee” will be
produced.
. Volume:
You can press the key programmed to
“ cancel squelch” to receive background
noise and then turn the Power/Volume key
to adjust the volume.
. Channel:
Turn the channel selector knob to select
the required channel. When the correct signal
is received, you can hear sounds from the
speaker.
. Transmission:
To send a call, press the PTT key and speak to
the microphone in the normal voice. Please keep
the microphone about 3 or 4 cm far from your mouth.
. Receive:
The radio will return to the receiving state after
you loosen the PTT key. The distributor may have
set the CTCSS/DCS signaling in the programmed
radio of your radio. On the channels with CTCSS
/DCS are set, you can only hear the call from other
radio with the same CTCSS/DCS.
5. Programmable Key Function
Top key, side key 1, side key 2 can be programmed as one of the
following functions.
Keys
0. None
1.Voice
announcement
selector
2.Talkaround
Function Description
No function
Press this programmable key to switch between
different languages and modes of voice announ-
-cement and hear the number of channels being
broadcast.
Switch the radio between talkaround and repeater