Instruction manual

32
2. Preparation
2.1 Charge the battery
Insert the cable of the power adaptor
into the adaptor jack at the back of
the charger, insert the power adaptor
into applicable AC power output socket,
the 1 LED lights will flash for about 1
second, the green light will be on
constantly when normal.
Insert the battery to be charged or the radio in the charger, please
switch off the radio before installing it into the charger.
Make sure that the terminals of the battery and the charger can
contact with each other reliably, when the red LED is on, the char-
ging starts.
After about 5 hours of charging, the red LED will be out, and the green
LED will be on, which indicates that the battery is fully charged.
When the green LED is on, you can remove the battery, when the
battery reaches its best performance, then you can remove the power
adaptor from the AC power output socket.
If the yellow LED flashes, that indicates abnormal charging tempe-
rature or circuit, and the charger is in the protected status, in which
you should not charge the battery compulsorily, please remove the
battery and shut the power of the charger.
Note:
The battery has not been charged when leaving the factory, please
charge the battery before using the radio for the first time.
After being purchased or before the first charging after being laid
aside for a long time (2 months), the battery can reach its normal
capacity after several times of charging, please ensure to charge
the battery for at least once every three months.
When the battery is fully charged or not used till the low battery alarm
status of the radio, it's better not to recharge it so as to avoid influe-
nce its longevity and performance. Please remove the battery from
the charger after the charging.
Battery pack is provided with internal protective circuit, in the low
battery status, it will cut the power automatically, if it's charged on the
charger now, the red LED will not be on immediately, about 1-5
minutes later, the charging indicators will turn normal.
2.2 Install/remove the battery
Align the two protrusions at the lower
end of the battery to the slot at the
lower part of the shell of the radio
and insert in.
Install the battery