Instruction manual

14
15
If Transmission End has been set, when you release the PTT switch,
the ID signals will be transmitted.
If both have been set, the ID signals will be transmitted respectively
when you press and release the PTT switch.
6.10 Lone worker
If Lone worker is set to be enabled, press the key “ Lone worker” to
enable the Lone Worker Mode. Start the Lone worker timer and when
the preset Lone worker time is reached, the radio will alarm, after the
alarm time, the radio will enter the Emergency Alarm Mode and give
out the Emergency Alarm.
In the Lone worker Mode, press the “ Lone worker” key again to quit
the Lone worker mode.
In the Lone worker Mode, press the key programmed for “ Lone worker
reset” (the specific key to select lone worker reset mode) or any key
(any key to select lone worker reset mode), the Lone worker timer will
start timing again.
6.11 Emergency Alarm
Press the key programmed for “ Emergency Alarm” (the time of
pressing must be longer than the de-bounce time of the emergency
alarm switch) to enter the Emergency Alarm mode. You can set alarm
tone according to the programming software or send your own ID or
background tone to your friend or the system.
In the Emergency Alarm Mode, press the key“ Emergency Alarm Off”
to quit the Emergency Alarm Mode and disable the alarm tone or stop
sending it and resume normal operation.
7. Wired Clone Mode
If the wired clone function is enabled, the radio will not quit after
entering the wired clone mode. To return to normal user mode, the
user needs to restart the machine.
The operating steps go as follows:
1. Press side key 1 for power-on at least 2 seconds and enter the clone
mode. If the function is disabled, it will enter the user mode.
2. Connect the slave radio with the wired clone cable first, and then
turn on.
3. Press side key 2 on the master radio for starting clone. During
transmitting the data, the master radio lightens red, and the slave
radio lightens green . After the slave radio receiving all the data,
the red light on the master radio is off, and the slave radio restarts.
4. You can keep copying according to step 3 above.
8. Trouble Shooting Guide
No.
1
2
Problem
Power on Failure
Phase lock loop
unlocked (Beeping)
Solution
A. Unreliable connection between the battery
and the radio, please reinstall the batter.
B. The protective tube of power is burnt out.
Please change it.
C. Power switch in failure, please change it.
D. The rechargeable battery is out of power.
Please recharge or change a new one.
E. CPU is broken, Please change the IC.
A. Channel frequency beyond the range,
reset channel data.