Instruction manual

10
11
b)After the alarm, when the time of transmission exceeds the preset
time, the TOT timer will act.
4) TOT reset time:
a) Limiting the time delay from the PTT key is loosened to the timer
resets.
b) If the time of releasing the PTT key is shorter than that of the reset,
the countdown continues.
6.2 battery saving
The dealer may set the energy saving modes of the battery by
programming.
If this function is enabled, the radio will enter the battery saving mode
If not receiving any signal or any operation for 10 seconds. The radio
will automatically quit the battery saving mode if receiving any signal or
operation.
There are 4 modes of battery saving: 1:1, 1:2, 1:4 and off.
This function can reduce the power consumption of the battery.
6.3 Low battery alarm
In the low battery status, the indicator will flash for prompt. If the battery
level is so low as to reach the preset value during transmission of
signals, the red indicator will flash. When the battery level is too low, the
radio is not capable of transmitting signals.
6.4 Voice announcement
This feature can be enabled or disabled by the dealer and has two
language modes: Chinese and English.
When changing the channel with the channel selector, after the cha-
nnel is changed, the radio will announce the number of the channel
selected.
6.5 CTCSS /DCS
The dealer may have programmed CTCSS or DCS signals on cha-
nnels of the radio, you can ignore calls of other irrespective radios
using the same channel.
When a certain channel is provided with CTCSS or DCS signals, the
squelch is only enabled when receiving correct CTCSS or DCS signals.
Similarly, only radios with the CTCSS/DCS signals con forming to
that of your radio can receive your signal.
Note: Although it appears that once you use CTCSS/DCS, you can
have your own channel, if other radios set the same CTCSS or DCS
signals, they can still hear your calling.
6.6 Dual Tone Multi-Frequency (DTMF) Coding
DTMF signaling can be set into code sequence by the dealer, when
the coding template contains DTMF signaling, press corresponding
programmable keys “ Call 1”“Call2” , the codes can be
transmitted.
6.7 Talkaround
In the communication network, you can expand communication range
through the repeater, but when the radio is out of the communication
range, you can connect with other radio in the talkaround method.
Switch the talkaround or repeater mode through “ Talkaround” key.
Remark: if you have higher requirement on the decoding time, please
set the power saving mode to "close" or "1:1".