User's Manual
Table Of Contents
- Ref. V10-122006
- Features
- Mullion Mounting
- Indications
- Connections
- Output protocols
- Security
- Specifications
- Timing
- Installation instruction
- Mullion Mounting
- Connector Assignments
- Tamper Switch
- Mounting tool
- Mounting Plate (Spacer)
- _
- _
- _
- © Copyright 2007
- Issue: May 2007 – This manual supercedes and rend
- The information in this manual has been put toget
- The installation recommendations contained in this manual assume the most favorable framework conditions. The manufacturer cannot guarantee that the system will function perfectly under other conditions.
- The manufacturer cannot guarantee that the information contained in this document is not protected by external property rights. The manufacturer is not granting licenses to its own or external patents or other property right.
- _
- _
- _
Output protocols
The Smart ID Reader Family can operate with any
facility, system or card coding scheme. The output
format, contents and length are determined by the
personalization of the card or configuration of the
reader. Output formats like magstripe, Wiegand and
several others are available.
The readers are intended for connection to an Access
Control Panel where compatibility to the reader is
referenced in the control unit’s installation instructions.
Security
Depending on the model and the RF technology used
the Smart ID Reader Family offers high security
challenge response schemes to protect the RFID air
interface against various attacks schemes like record &
playback attacks.
Specifications
Typical read range with an ISO Card
EM4102 up to 7.5 cm (2.9 inch)
Hitag1&2 up to 8 cm (3.2 inch)
ISO14443 up to 3 cm (1.2 inch)
Legic up to 4 cm (1.6 inch)
ISO15693 up to 15 cm (5.9 inch)
DESFire up to 2 cm (0.8 inch)
Power Supply
4,5 – 16 Volt DC
6