User's Manual

2
2.1.3 ISO 14443 Cards
Your dealer, or Integrated Engineering, normally provides suitable cards with the
reader.
There are, however, certain requirements for cards that are to be used with the
SmartTOUCH
TM
Xtreme reader. These requirements are summarized in chapter
2.5 Requirements for ISO 14443 Cards on page 7.
2.1.4 Components
The SmartTOUCH
TM
Xtreme reader is delivered with the following components:
1. The SmartTOUCH
TM
Xtreme reader with this manual.
2. A Config card to configure this reader and possible other readers for a
specific system/site.
3. An Enroll card to write one or two fingerscan templates on an ISO 14443
card. For more information, see chapter 2.4 The Enroll card and the Erase
card on 6.
4. An Erase card to erase templates from an ISO 14443 card.
2.2 Installation
2.2.1 Mounting and connections
The reader is built to provide easy mounting next to doors. Please note that the
reader has to be mounted on the correct height for correctly presenting fingers to
the reader. The usage in Europe is ergonomic optimal at a height of at least 135
cm (53 inches) from the ground. It is better to mount the reader too high than too
low!!
The reader can also be mounted on an European or US wall socket.
Mounting directly on the wall: Drill the fastening holes for the SmartTOUCH
TM
Xtreme reader see Figure 1: Drawing 71309764, SmartTOUCHTM Xtreme:
mounting and installation on page 15.
Remove the detachable connector and wire the reader connector appropriately as
shown in Table 1: SmartTOUCHTM Xtreme connector assignements on page 14. After
that, attach the connector to the reader and mount the reader on the wall. Test
the reader before closing the housing with bottom screws.
Note:
The supply voltage must be between 8 and 24 volt. The
SmartTOUCH
TM
Xtreme will not function properly if the voltage is lower.
The electronics can be damaged if higher voltages are used.