User's Manual

1
2.1 Introduction
The SmartTOUCH
TM
Xtreme reader is an access control proximity reader, which
provides a higher level of security: an authorized card alone is not sufficient to
obtain access. A fingerprint of the cardholder, which must agree with the template
stored on the card, is also required. Use of a card by unauthorized personnel is
therefore not possible.
The SmartTOUCH
TM
Xtreme reader is a combination of an ISO 14443 reader and a
FingerScan module. The SmartTOUCH
TM
Xtreme reader makes it possible to store
fingerprint templates on ISO 14443 cards in Enroll mode and verifies cards in
Access Control mode. After comparing the stored template with the fingerscan of
the user, the access control information in the card is sent to an external system.
The external system is completely independent of the fingerprint information,
which is only stored on the user’s card and no where else. This prevents problems
with the privacy regulations.
The reader is built with a narrow housing to provide easy mounting next to doors.
Please note that the reader has to be mounted on the correct height for
presenting the finger to the reader.
The backplate is prepared for mounting the reader on a European of US wall
socket.
The SmartTOUCH
TM
Xtreme is prepared for outside use. For extreme, low
temperature conditions an optional heater is needed.
This document describes the installation procedure, the functions, and the
specifications of the SmartTOUCH
TM
Xtreme reader. The information in this
document is based on the software version V102.
Please note that the SmartTOUCH
TM
Xtreme uses minutea based templates. The
SmartTOUCH
TM
Xtreme templates are incompatable with the templates of the
SmartID and Classic SmartTOUCH
TM
readers.
2.1.1 Electrical Connections
The SmartTOUCH
TM
Xtreme reader is an identification and verification unit to be
used in combination with an external system. For installation and connections see
Figure 1: Drawing 71309764, SmartTOUCHTM Xtreme: mounting and installation
and Table 1: SmartTOUCHTM Xtreme connector assignements.
2.1.2 Access Control Data format
The reader can read two types of data: the serial number of the card, or data that
is stored in the card. The data transfer protocol can be determined by information
on the card itself or by the configuration of the reader. The SmartTOUCH
TM
Xtreme
reader supports:
• clock and data ABA track 2 emulation
• Wiegand
• Clock and Data
• RS232 / RS422 / RS485 read-only output and
• PDP-1 RS485 multi-drop protocol
Contact Integrated Engineering for further information.
2. SmartTOUCH
TM
Xtreme