User's Manual

Table of Contents

1. Introduction iv

1.1 General information iv

2. SmartTOUCH

Xtreme 1

2.1 Introduction 1

2.1.1 Electrical Connections 1

2.1.2 Access Control Data format 1

2.1.3 ISO 14443 Cards 2

2.1.4 Components 2

2.2 Installation 2

2.2.1 Mounting and connections 2

2.2.2 Initializing the Reader 3

2.3 Using SmartTOUCH

Xtreme 3

2.3.1 Enroll mode: storing a fingerscan template in an ISO 14443 card 3

2.3.2 Access mode: Obtaining access 4

2.3.3 Erase mode: Erasing an ISO 14443 card 5

2.4 The Enroll card and the Erase card 6

2.4.1 Activating an Enroll card and an Erase card 6

2.4.2 Programming an Enroll card/Erase card 6

2.5 Requirements for ISO 14443 Cards 7

2.6 Appendix 8

2.6.1 SmartTOUCH

Xtreme initialization sequence 8

2.6.2 SmartTOUCH

Xtreme LED behavior 8

2.6.3 Possible Errors 9

2.6.4 SmartTOUCH

Xtreme and other SmartTOUCH

readers. 10

Short product specifications and part numbers/article codes 11

Cable Distance 11

SIA recommended cable type for Wiegand signals 11

Wiegand Signal Levels 12

Reader output interface and pull-up resistors 12

3. Drawings 15

Figure 1: Drawing 71309764, SmartTOUCH

Xtreme: mounting and installation 15