User's Manual

1.1 General information

This document describes the installation procedure and operating instructions of the

SmartTOUCH

Xtreme combined ISO 14443 and biometric finger print reader.

Certificate:

CE : pending

FCC : pending

Consult your National Authority if any listings are needed for this product.

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following

two conditions:

1) that this device does not cause harmful interference, and

2) that this device must accept any interference received, including interference that may

cause undesired operation.

No part of this document may be reproduced, translated into another language, stored in

a retrieval system or transmitted in any form or by any means electronic, mechanical,

photocopying, recording or otherwise without the prior written consent of Integrated

Engineering.

Disclaimer:

The information in this document is subject to change without prior notification.

Every precaution has been taken in the preparation of this document. Integrated

Engineering assumes no responsibility for errors or omissions. Neither any liability will be

assumed for direct or indirect damages resulting from the use of the information

contained in this document.

Trademarks:

SmartID

, SmartLOGON

, and SmartTOUCH

are trademarks of Integrated

Engineering.

MIFARE® is a registered trademark of Philips Royal Electronics N.V.

1. Introduction