User's Manual

In order to obtain access, follow the following procedure:

! Present an ISO 14443 card with access control information and fingerscan

template(s) to the reader.

o If a valid card is read the reader will beep and the bottom LED starts

blinking green (maximum 5 seconds).

This indicates that the card holder must place his/her finger on the

scanner. If this is not done within the allocated time (5 seconds), the

bottom LED will turn off and the card must be presented again.

! Within 5 seconds place a finger on the scanner.

o If the finger is scanned and the data is verified successfully, the reader will

beep and the bottom LED will turn green for a short time to show that the

card data will be sent to the external system.

o If the scanned finger does not match the data on the card, the buzzer will

beep three times and the bottom LED will blink red.

Note:

Scanning and processing of the fingerscan can be slower if two

fingerscan templates are present on the card. If the fingerscan does not

match with the first template on the card, the reader must match the

second template.

2.3.3 Erase mode: Erasing an ISO 14443 card

Stored fingerscan template(s) can be erased from ISO 14443 cards using the

Erase mode.

A valid Erase card is necessary in order to switch the reader from Access mode to

Erase mode.

After being powered on, the reader is in Access mode.

! Present a valid Erase card.

o If the card is valid, the top LED will turn red and the bottom LED starts

blinking red. This indicates that the reader is in Erase mode. The reader

waits a maximum of 5 seconds for a card with templates to erase. The

reader will return to Access mode if no card is presented to the reader

within 5 seconds.

! Present an ISO 14443 card with fingerscan templates.

o The bottom LED will turn red while the card is being erased.

o The reader will beep once when the card has been erased. The reader will

then return to Access mode.

o The reader will beep three times and return to Access mode if an error

occurs during the erase procedure.

The SmartTOUCH

Xtreme reader is programmed to return to Access mode in

order to avoid accidental erasure of cards