User's Manual

EN
paged handset will show “INT CALL”.
NOTE: To cancel the intercom call, press TALK.
1. Press TALK to answer an intercom call.
2. Press TALK to end the intercom call.
If an external call comes in during an intercom
conversation, you will hear a call waiting tone.
1. To end an intercom call, press TALK.
2. The external line will ring. Press TALK again to
answer the external call.
You can transfer an external call from one
handset to another.
1. During an external phone conversation, press
INT. Your caller will be put on hold.
2. Type in the handset number (1-4) to which you
want the call transferred.
3. The paged handset will ring and “INT CALL”
will appear on the display.
4. To answer the call on the paged handset, press
TALK.
5. Press TALK on the paging handset to complete
the operation.
NOTE: If the other handset does not answer,
press INT to end the intercom call and get back to
the external line. Pressing TALK will end both the
intercom call and the external call.
The handset and Base Unit shall be factory pre-
registered among each other with the identification
digital security codes, which are stored into the
non-volatile memory. Therefore, the unit should
ANSWERING INTERCOM CALLS
CALL WAITING
CALL TRANSFER BETWEEN HAND-
SETS
be in full working order out of the box.
When you purchase an additional handset, you
have to register it to the Base Unit in order to
make and answer calls.
You can register up to 3 more handsets to make
and answer calls via the same Base Unit.
Handsets are numbered 1 to 4.
To register a new handset:
1. On the handset, press MENU.
2. Use the ARROW KEYS to select “Handset
Setting”, then press MENU.
3. Select “Registration”, then press MENU.
4. Select “Yes” then press MENU. (You will see
the message: “Registering”).
5. Press and hold the PAGE button on the cradle
of the base unit.
NOTE: The Base Unit will then send a signal to the
handset registering the handset to the Base Unit.
Once the registration function has been
completed, the handset will return to Standby
Mode.
To de-register handsets to the base unit:
1. On the handset, press MENU.
2. Use the ARROW KEYS to select “Handset
Setting,” then press MENU.
3. Select “Remove HS”, then press MENU.
4. Use the ARROW KEYS to select the handset
number, then press MENU.
5. Select “Yes,” then press MENU to confirm the
de-registration.
17
REGISTRATION PROCEDURE
DE-REGISTRATION OF HANDSETS
REGISTERING HANDSETS TO
BASE UNIT
manual-E1.p65 2004/12/10, AM 10:3521