User's Manual
EN
USING MULTIPLE HANDSETS
INTERCOM CALLING BETWEEN
HANDSETS
more seconds. You should now see “24hr/12hr”
flashing on the bottom left of the screen.
3. Press the SET button 4 more times to change
the flashing image to a “C” in the lower right of
the screen.
4. Use the ARROW KEYS to select either Celsius or
Fahrenheit, then press the SET button.
There are two channels for the dual alarm
function. To choose one of the alarms:
1. Press the ALARM button on the Base Unit to
select alarm ((1)).
2. Press the ALARM button again to change it to
alarm ((2)), or press ALARM again to select
alarm ((1)).
3. Use the ARROW KEYS to set the time of the
alarm.
4. When time is set, press the SET key to set
the alarm.
NOTE: Your Base Unit has 2 daily crescendo
alarms. If both set, the alarms will sound daily at
the set time.
Once an alarm sounds, you have two options:
Option 1:
1. Press any key except the SNOOZE button to
turn the alarm off completely.
Option 2:
1. Press the SNOOZE button. (The alarm will
return on after 8 minutes).
This sensor works as a radio-frequency clock
transmitter for the Base Unit. This remote sensor
is used to transmit radio frequency signals for the
radio-controlled clock, and to measure the
temperature and humidity.
TURNING THE ALARM OFF
Mount the remote sensor on a flat surface using
the recess holes in the back of the unit. (You
need to slip on the white wall-mount bracket to get
a recess hole).
Additional sensors can be purchased to allow
reporting from up to 3 locations.
Place the remote sensor somewhere dry outside
so that you can read the temperature and humi-
dity, as well as forecast the weather.
For best results:
• Do not place the sensor in direct sunlight or
moisture.
• Position the sensor so that it faces the indoor
Base Unit.
• Minimize obstructions, such as doors, walls
and furniture.
• To maximize radio frequency reception for the
clock, place the remote unit in a location with a
clear view to the sky. You may need to
experiment with various locations to find the
best reception.
NOTE: Please note that the remote sensor must
be placed within 300 meters of the Base Unit to
be fully functional.
Your base unit can synchronize with up to 4
handsets. If you have multiple handsets
registered with the base, 2 handsets can make
intercom calls.
1. Press INT on your handset.
2. Type in the number of the handset (1-4) that
you want to reach.
3. The paged handset will ring. The display of the
SETTING THE BASE UNIT ALARM
INSTALLING THE SENSOR
16
manual-E1.p65 2004/12/10, AM 10:3520