User's Manual
EN
This feature is very useful if you can’t remember
where you put your handset. Make the lost hand-
set ring for a fixed time of 2 minutes by pressing
PAGE in the cradle on the Base Unit.
NOTE: You cannot have an intercom conversation
between a handset and the Base Unit.
• To look for all handsets, press the PAGE
button in the cradle of the Base Unit.
• To stop the paging, select any key on the
handset or press the PAGE button again.
1. Press the ALARM button 2 or 3 times to set it
at the month-and-day screen.
2. Press and hold down the SET button for 2 or
more seconds. You should now see “24hr/12hr”
flashing on the bottom left of the screen.
3. Press the SET button again to change the
flashing image to the time.
4. Use the ARROW KEYS to change the time
5. Once the time is set, press the SET button
five more times to escape the set-up mode.
NOTE: Updating the date and time on the Base
Unit will synchronize all other handsets.
1. Press the ALARM button 2 or 3 times to set it
at the month-and-day screen.
2. Press and hold down the SET button for 2 or
more seconds. You should now see “24hr/12hr”
flashing on the bottom left of the screen.
3. Use the ARROW KEYS to change the time
format.
NOTE: By entering this mode, you can also
change time display, M/D vs. D/M, date and
month and Fahrenheit and Celsius (see below for
more instruction).
PAGING THE HANDSETS
SETTING THE BASE UNIT TIME
4. When set, then press the SET to escape set-
up mode.
NOTE: By pressing and holding down the UP or
DOWN buttons, you can increase or decrease the
settings at a much faster rate.
1. Press the ALARM button 2 or 3 times to set it
at the month-and-day screen.
2. Press and hold down the SET button for 2 or
more seconds. You should now see “24hr/12hr”
flashing on the bottom left of the screen.
3. Press the SET button twice more to change
the flashing image to the date in the lower right
of the screen.
4. Use the ARROW KEYS to change the date
format.
5. Once the time is set, then press the SET
to escape set-up mode.
1. Press the ALARM button 2 or 3 times to set it
at the month-and-day screen.
2. Press and hold down the SET button for 2 or
more seconds. You should now see “24hr/12hr”
flashing on the bottom left of the screen.
3. Press the SET button 3 more times to change
the flashing image to the date in the lower right
of the screen.
4. Use the ARROW KEYS to change the date,
then press the SET to escape set-up mode.
NOTE: The latest setting on any handset will
supercede the previous setting on other handsets
and Base Unit.
1. Press the ALARM button 2 or 3 times to set it
at the month-and-day screen.
2. Press and hold down the SET button for 2 or
SETTING THE DATE FORMAT
SETTING THE DATE
SETTING THE TIME FORMAT
15
SELECTING CESIUS OR FAHRENHEIT
manual-E1.p65 2004/12/10, AM 10:3519