User's Manual

EN
When the battery is fully charged, the handset
battery icon will show the battery full in the top
right on the LCD display.
Due to radio interference in the environment,
occasional loss of synchronization between the
handset and base may occur for a very short
duration. The base will very quickly change to
another channel automatically to overcome the
interference and restore synchronization.
Do not install the base unit near a sink, bath
or shower, or anywhere else where it could get
wet. Electrical equipment can cause serious
injury if used while you are wet or standing in
water.
If the base unit ever falls into water, do not
retrieve it until you have unplugged the power
lead from the mains and the telephone line
plug from the telephone socket; then pull it out
by the unplugged cables.
Never use your weather phone in the open air
during a thunderstorm - unplug the Base Unit
from the telephone line and the main socket
when there are storms in your area. Damage
caused to your phone by lightning is not
covered by the guarantee.
Usually, a loss of reception means you are too
far from the Base Unit, or there is interference
between the two units. Make sure to:
Stay within a range of 300 meters from the
Base Unit while using the handset.
FINAL SAFETY TIPS
ELECTRICAL SAFETY
Avoid interference such as TV or other
electrical appliances.
NOTE: In this user manual, all BOLDED,
capitalized letters are buttons that appear in your
new weather phone.
Using the TALK button:
1. Press TALK to get the dial tone, and dial the
number. If you make a mistake, press TALK
again to cancel the whole number.
OR
2. Dial the number then press TALK.
NOTE: You can use the TALK button to toggle
between Talk Mode and Standby Mode.
Using the Speakerphone (SPK) button:
1. Press SPK to get the dial tone, and dial the
number.
OR
2. Dial the number then press SPK.
NOTE: If you are in Speakerphone Mode and you
want to use the handset, press TALK to switch off
the speakerphone first.
The handset will ring when there is an external call.
Press TALK OR press SPK. (This will enable
the speakerphone function).
NOTE: If the handset is placed in the recharge
cradle of the Base Unit when it is in Talk Mode, it
will automatically enter the Standby Mode.
Press TALK.
BASIC FUNCTIONS
MAKING A CALL
7
ANSWERING A CALL
ENDING A CALL
manual-E1.p65 2004/12/10, AM 10:3311