User's Manual

EN
4
REMOTE SENSOR - BACK VIEW
1. RESET button
2. °C / °F switch
3. Channel selection switch
4. Battery compartment
GETTING STARTED
Some cordless telephones operate at frequencies
that may cause interference to nearby TVs,
microwave ovens and VCRs. To minimize or
prevent such interference, the base of the
cordless telephone should not be placed near or
on top of a TV, microwave oven or VCR. If such
interference continues, move the cordless
telephone farther away from these appliances.
Certain other communication devices may also
use the 2.4GHz frequency for communication
and, if not set properly, these devices may
interfere with your new telephone.
Typical devices that may use the 2.4GH
frequency include wireless audio/video senders,
wireless computer networks and multi-handset
cordless telephone systems.
CHOOSING BASE UNIT LOCATION
When selecting a location for your base unit
(which records and displays the indoor tempera-
ture), please observe the following guidelines:
• Choose a location that provides easy access
to a 120-volt AC power source.
• Choose a location that will allow the telephone
cable to reach a telephone jack. (You can use
an extension cable if necessary).
• Place the base unit as high as possible to get
a better radio frequency range with the
handset. You may need to try several
locations – such as upstairs, or near a first-
floor landing – to find the best range. Solid
structures, such as walls and doors, may
reduce the signal strength.
• Do not place the base unit near a sink, bathtub
or shower.
• Do not place the base unit near large metal
objects or electronic appliances that may
cause radio interference. Some of these
include: mirrors, filing cabinets, electric
stoves, washing machines, microwave ovens,
televisions, fluorescent lights or other
telephones.
• Do not place the unit near heat sources, such
as radiators or air ducts, or in a place subject
to direct sunlight.
CONNECTING THE BASE UNIT
To connect the base unit:
1. Plug the AC adaptor into the power jack on
the back of the base, and then plug the
other end into an electrical outlet.
2. Plug the telephone line cord into the
telephone line jack on the back of the base
unit, and then plug the other end into a
modular phone jack.
NOTE : The adaptor is shipped with the product.
Please check the label on the adaptor to make
sure you are using the right one.
NOTE : You need a RJ11 modular phone jack. If
you do not have a modular jack, call your local
phone company to find out how to get one
installed.
REMOTE SENSOR SETUP
This product measures the outdoor temperature
and then transmits the information to the base
unit. It can be used with up to 2 other remote
sensors to transmit data back to the base unit.
Additional remote sensors that measure tempera-
ture are sold separately.
NOTE : If you are using more than one remote
sensor, be sure to select a different channel for
TW339 manual_Eng 5.p65 3/5/05, 9:23 AM7