User's Manual

EN
13
IDENTIFYING A HANDSET ON THE
NETWORK
If you have more than one handset registered to
a base unit, you can identify each handset by
assigning a name to it. Please see the HANDSET
NAME section for more information.
INTERCOM (INTERNAL) CALLS
This feature only works if you have 2 or more
handsets registered to the base unit.
To make an internal call:
1. Press INT on the first handset.
2. Press or to select the desired handset
or choose “CALL ALL”.
3. Press TALK to place the call. The selected
handset will ring. If you select “CALL ALL”, all
other handsets registered to the base unit will
ring. If the selected handset is not available
(off hook or on another call), “BUSY” shows.
4. To accept the intercom call on the handset,
press TALK.
5. To exit intercom mode on the first handset,
press TALK.
NOTE : During the first handset calls the other
handset, there may be an incoming call in which
the first handset will hear a call waiting tone and
the other handset will return to normal incoming
call tone.
INTERCOM RING TONE
You can change the ring tone for an intercom call
to differentiate internal from external calls. To
change the ring tone, please see HANDSET RING
TONE SETTING on page 16 for more information.
CALL TOGGLING
This feature only works if you have two or more
handsets registered to the base unit. The feature
allows you to put an external call on hold while
you place an intercom call to another handset.
To toggle between two calls:
3-WAY CONFERENCE CALL
If you have more than one handset registered
with your base unit, you can make 3-way
conference calls between an external call party
and two internal handset holders.
To initiate a 3-way conference call:
1. Establish contact with the external party by
either placing a call to that person, or
answering an incoming call.
2. Press INT then press or to choose a
handset name.
3. Press TALK to connect to the selected
handset. (The handset you paged rings. The
internal party can answer the call by pressing
the TALK key).
4. The caller who made the conference call
should press and hold the INT key for
approximately 2 seconds until “CONFER-
ENCE CALL” shows on the display and you
hear a confirmation beep. (All three parties
are connected into the call and can thus talk
together).
1. Establish contact with an external party by
either placing a call or answering an incoming
call.
2. Press INT to put the external call on hold and
enter intercom mode.
3. Press the number (1-4) for the handset you
wish to select, or use the or keys to
select the handset.
4. Press TALK to place an intercom call to the
selected handset. “H” shows on the display to
indicate the external call is on hold.
5. Press INT on the handset. This initiates call
toggling to place the intercom call on hold and
return to the external call.
6. Press the TALK key on the selected handset
to end the intercom call and return to the
external call.
NOTE : If the selected handset is not available,
“BUSY” shows and then a call back is generated.
“CALL BACK” is displayed on the handset display.
You can press TALK to return to the caller.
TW339 manual_Eng 5.p65 3/5/05, 9:23 AM16