User's Manual

EN
8
3. Press MENU/OK to enter settings.
4. Press or to select “OFF” or “ON”.
5. Press MENU/OK to confirm your selection.
(The default setting is OFF).
CLEAR MESSAGE WAITING
To clear message waiting:
1. Press the MENU/OK key.
2. Press or to select “CLEAR MSG
WAIT”.
3. Press MENU/OK. The screen will show
“CONFIRM?”
4. Press MENU/OK again to confirm, or press
C/MUTE repeatedly to return to stand-by
mode.
BASICS
When you first set up your telephone, you may
hear a beeping tone and see “OUT OF SERVICE”
on the handset display area. This is normal. It
means that the handset needs to synchronize with
the base unit before you can use it.
Place the handset on the charger for a few
seconds until “READY” appears on the handset
display.
STAND-BY MODE
If the handset is synchronized with the base unit
and is not “in use” or in “programming mode”,
“READY” (or a name if entered) will appear on the
LCD display. This is standby mode.
RECEIVING A C ALL
When an incoming call is received, the handset
will ring, “EXTERNAL CALL” will show on the
display and the in-use LED on the base unit will
flash. If you are already on the line, a beep will
announce you have a call waiting.
NOTE : If you subscribe to a caller ID service
from your phone company, caller ID information
will be shown on the display instead of “EXTER-
NAL CALL”.
To receive a call:
1. Press TALK, the # key or any number key
(0-9) to answer a call.
2. Press the TALK button again to hang up.
NOTE : If the handset is in the base cradle,
remove it from the base before pressing the TALK
key. If “AUTO ANSWER” is enabled, you can
accept an incoming call by simply lifting the
handset off the base.
NOTE : If you place the handset back to the
base cradle, the handset will automatically hang
up.
MAKING A CALL
To make a call, press TALK to get a dial tone then
enter the number, or dial the number first (up to
24 digits) then press TALK.
To end the call, press TALK again or place the
handset on the base cradle so the handset
automatically hangs up. (“ENDED” will appear on
the display to confirm that the call has ended).
CORRECTING A CALL
You can correct a dialing error before the number
has been dialed (i.e. before pressing talk). To
correct a dialing error you can do one of the
following:
• Press the FLASH/DEL key to clear the digits
one by one.
• Press and hold FLASH/DEL to clear all the
digits at once.
• Press C/MUTE to clear all the digits at once.
REDIALING
To redial one of the last 5 numbers called, you can
do one of the following:
1. Make sure the phone is OFF (not in TALK
mode).
2. Press REDIAL/PAUSE repeatedly to select a
desired last number, and then press TALK to
redial the selected number.
OR
1. Make sure the phone is ON by pressing TALK.
TW339 manual_Eng 5.p65 3/5/05, 9:23 AM11