User's Manual

33
CONSUMER INFORMATION
This equipment complies with Part 68
of the FCC rules and the requirements
adopted by the ACTA. On the bottom of
this equipment is a label that contains,
among other information, a product
identifier in the format
US: KT5W400BPM58XX. If requested,
this number must be provided to the
telephone company.
An applicable certification jack Universal
Service Order Codes (USOC) for the
equipment is provided (i.e., RJ11C) in the
packaging with each piece of approved
terminal equipment.
A plug and jack used to connect this
equipment to the premises’ wiring and
telephone network must comply with the
applicable FCC Part 68 rules and require-
ments adopted by the ACTA. A compli-
ant telephone cord and modular plug is
provided with this product. It is designed
to connect to a compatible modular jack
that is also compliant. See installation in-
structions for details.
The REN is used to determine the num-
ber of devices that may be connected to
a telephone line. Excessive RENs on a
telephone line may result in the device
not ringing in response to an incoming
call. In most but not all areas, the sum of
RENs should not exceed five (5.0). To
be certain of the number of devices that
may be connected to a line, as deter-
mined by the total RENs, contact the lo-
cal telephone company. [For products
approved after July 23, 2001, the REN
for this product is part of the product
identifier that has the format
US:KT5W400BPM58XX. The digits re-
presented by 0.0B are the REN without
a decimal point (e.g., 03 is a REN of 0.3).
For earlier products, the REN is sepa-
rately shown on the label].
If this equipment PM5821causes harm
to the telephone network, the telephone
company will notify you in advance that
temporary discontinuance of service
may be required. But if advance notice
isn’t practical, the telephone company
will notify the customer as soon as
possible. Also, you will be advised of
your right to file a complaint with the FCC
if you believe it is necessary.
The telephone company may make
changes in its facilities, equipment, op-
erations or procedures that could affect
the operation of this equipment. If this
happens the telephone company will
provide advance notice in order for you
to make necessary modifications to main-
tain uninterrupted service.
Should you experience trouble with this
equipment, please contact:
www.phonemate.com
Minneapolis Service Center
10901 Louisiana Ave. So.
Bloomington, MN
USA
55438
for repair or warranty information. If
the equipment is causing harm to the
telephone network, the telephone
company may request that you
PM5821manual 21mar.p65 2006/5/12, ¤U¤È 05:4933