User's Manual
26
3. Press or to set TS (Toll Saver: the call is answered after the short toll
ring), 2, 4, 6 or 8 rings.
4. Press
MENU to conrm and exit to standby mode. A beep will sound to
indicate the setting is conrmed.
Set the time
1. Press MENU, then press TIME. The voice prompt will read the current time
and day and
will be displayed.
2. The setting for day will ash. (01 indicates Monday, 02 Tuesday etc.)
3. Press
or to change the setting. The voice prompt will announce the
new value.
4. Press
MENU to conrm.
5.
Repeat steps 3 and 4 to set the remaining settings:
•
Hour: 00 to 23 hours.
•
Hour Format: --' for 24hr, A/P for 12hr (am/pm depending on the hour
setting)
.
•
Minute: 00 to 59 minutes.
Hear the current time
Press TIME to hear the current time. The voice prompt will announce the day
and time.
Adjust the volume level
During announcement or messages playback, press or to increase or decrease
the volume.
Note: In Standby mode, the volume level (0 to 7) will be displayed.
Setup the remote access code
The remote access function allows you to remotely check your messages from
any external line. To retrieve the messages you need to enter a 4-digit remote
access code.
1. Press
MENU and use or to navigate to the remote access code
submenu. The voice prompt will say “Set remote access code” and
will show.
2. Press
MENU, the voice prompt will announce the current code and the rst 2
digits (‘00’ to ‘99’) of the code will show with one digit blinking.
3. Press
or to set the value of the blinking digit.
manual-en-pm5851-re1.indd 26 2006/9/7 19:02:22