Owner's Manual

21
Wireless connection
■ Using Access Point Mode
1
Confirm that LED lights up in green.
LED lighting in blue indicates that connection to
network has been completed.
Note
• If Ethernet cable is being connected to the
DMI-40.4, pull the Ethernet cable out after
turning the power of DMI-40.4 off, and turn the
power on again and make the settings.
2
Press the Enter button on the remote
controller for five seconds.
The DMI-40.4 goes into Access Point mode and
wireless connection from your personal
computer enables thanks to the DMI-40.4’s SSID.
LED blinks in green.
3
Access the WEB settings menu (➔page 22)
from your personal computer and make
wireless settings.
LED lights up in blue once the connection
completes.
Tip
• You can also display the WEB settings menu by
entering the DMI-40.4’s IP address
“192.168.1.1” in the browser’s Internet address
(URL) field through Internet browser such as
Internet Explore
®
.