Firmware Instructions

1. Connect the USB Memory Device to the USB port of your computer
and copy the contents of the unzipped/extracted folder onto your
USB Memory Device.
2. Safely eject the USB Memory Device from your computer.
How to upgrade the firmware via USB:
1. Insert the USB Memory Device containing the software into the USB port
of the receiver.
2. Turn on the receiver and select the SETUP input on the front panel, then
select “8.Misc”, press Enter, then “8.1 F/W Update” and press Enter, scroll
down to select “Update via USB”.
3. Press the “Enter” button on the front panel to begin the update.
4. Do not shut the unit off until “Complete” is shown on the front display. This
will take up to 30 minutes.
5. Once the update has completed check the firmware version to confirm that
the unit is fully up to date. If it is not, run the update again.
To check the firmware version, press the SETUP button on the front
panel. Highlight “8.Misc” and press enter. Highlight “8.1 F/W Update” and
press Enter. Scroll down to the Firmware Version number to verify the
current installed version.
Current Version 1060-4030-1104
How to upgrade the firmware via Network:
1. If the unit is connected via LAN and there is firmware update available, the
"Firmware Update Available" message will appear. To execute updating,
select "Update Now" with the cursor buttons of the remote controller and
press ENTER. The unit automatically turns itself into standby mode about
3 minutes after "Completed!" appears on the display, and updating will be
complete.