Owner's Manual

EN
45
D Note for “IP Address”, “Subnet Mask”,
“Default Gateway”, “Primary DNS” and
“Secondary DNS”
• The range of input numbers is between 0 and 255.
• If you enter a number larger than 255, the number will
automatically be 255.
• When you enter a wrong number, select “Clear” to
clear. (The number will be back to “0”.)
• If you want to enter a 1 or 2-digit number in one cell,
press [Æ] to move on to the next cell.
D Note for “Proxy Address” and “Proxy Port”
• The range of input numbers for the port number is
between 0 and 65535. (If you enter a number larger
than 65535, it will be regarded as 65535.)
• For proxy port, certain ports might be closed, blocked
or unusable depending on your network environment.
• Choose a connection speed in accordance with your
network environment.
• When the settings are changed, the network
connection may be disabled depending on the device.
11.2 Analog Output
[Home ] → “Settings” → “Audio Out” → “Analog Output”
You can set the audio output from AUDIO OUTPUT
(ANALOG 7.1ch) jacks.
• When HDMI cable is connected, make sure
“Audio Output” in “HDMI” is set to “Off” to change
“Analog Output” in “Audio Out”.
■ Test Tone
“Test Tone” is the test tone which can be output from
the speakers so that you can adjust the volume for each
speaker.
• The test tone is output from AUDIO OUTPUT
(ANALOG 7.1ch) jacks in the order shown below.
The speaker which "Speaker Size" is set to "None" is
skipped.
Front Lch → Center → Subwoofer →
Front Rch → Surround Rch → Surround Back Rch →
Surround Back Lch → Surround Lch → Front Lch →
Center → …
■ Delay Time
This is a parameter for optimizing the timing at which
the sound is output from the speakers according to their
distance from the listening position.
• When you change “Front”, “Center”, “Surround” and
“Back” will be changed automatically to match “Front”.
Item Adjustment range Default setting
Front
0 ft / 0.0 m ~
60 ft / 18.0 m
12 ft / 3.6 m
Center
Surround
10 ft / 3.0 m
Surround Back
Default Reset “Delay Time” setting to the default.