Owner's Manual

4
Precautions
1.
Recording
Copyright-Unless
it's
for personal use
only, recording copyrighted material is illegal with-
out the permission
of
the copyright holder.
2. AC
Fuse-The
AC fuse inside the unit is not user-
serviceable.
If
you cannot tum on the unit, contact
your lntegra!Onkyo dealer.
3.
Care-Occasionally
you should dust the unit all
over with a soft cloth. For stubborn stains, use a soft
cloth dampened with a weak solution
of
mild deter-
gent and water. Dry the unit immediately afterwards
with a clean cloth. Don't use abrasive cloths, thin-
ners, alcohol,
or
other chemical solvents, because
they may damage the finish
or
remove the panel let-
tering.
4.
Power
WARNING
BEFORE
PLUGGING
IN
THE
UNIT
FOR
THE
FIRST
TIME,
READ
THE
FOLLOWING SEC-
TION
CAREFU
LLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets the
voltage requirements printed
on
the unit
's
rear panel
(e.g., AC
230
V,
50
Hz
or
AC
120
V,
60Hz)
.
The
power cord plug is used to disconnect this unit
from the
AC
power source. Make sure that the plug
is readily operable (easily accessible) at all times.
Pressing
the
[Standby/On]
button to select
Standby
mode does not fully shutdown the unit.
If
you do not
intend to use the unit for an extended period,
remove the power cord from the AC outlet.
5.
Preventing
Hearing
Loss
Caution
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
6.
Batteries
and
Heat
Exposure
Warning
Batteries (battery pack
or
batteries installed) shall
not
be
exposed to excessive heat as sunshine, tire
or
the like.
7.
Never
Touch
this
Unit
with
Wet
Hands
- Never
handle this unit
or
its power cord while your hands
are wet
or
damp.
If
water
or
any other liquid gets
inside this unit, have
it
checked by your Integral
Onkyo
dealer.
8.
Handling
Notes
•
If
you need to transport this unit, use the original
packaging to
pack
it how it was when you origi-
nally bought it.
•
Do
not leave rubber
or
plastic items on this unit
for a long time, because they may leave marks on
the case.
•
This unit's top and rear panels may get warm
after prolonged us
e.
This
is
normal.
•
If
you do not use this unit for a long time, it may
not work properly the next time you turn
it
on, so
be sure to use it occasionally.
•
When you've finished using this unit, remove all
discs and turn
off
the power.
9.
Installing
this
Unit
• Install this unit in a well-ventilated location.
•
Ensure that there's adequate ventilation all
around this unit, especially
if
it's
installed in an
audio rack.
If
the ventilation is inadequate, the
unit may overheat, leading to malfunction.
•
Do not expose this unit to direct sunlight
or
heat
sources, because its internal temperature may
rise, shortening the life
of
the optical pickup.
• Avoid damp and dusty places, and places subject
to vibrations from loudspeakers. Never put the
unit
on
top of,
or
directly above a loudspeaker.
•
Install this unit horizontally. Never use
it
on
its
side
or
on
a sloping surface, because it may cause
a malfunction.
•
If
you install this unit near a TV, radio,
or
VCR
,
the picture and sound quality may be affected.
If
this occurs, move this unit away from the TV,
radio,
or
VCR.
10.
Moisture
Condensation
Moisture
condensation
may
damage
this
unit.
Read the following carefully:
Moisture may condense
on
the lens
of
the optical
pickup, one
of
the most important parts inside this
unit.
•
Moisture condensation can occur in the following
situations:
-
The unit is moved from a cold place to a warm
place.
-
A heater is turned on,
or
cold air from an air
conditioner is hitting the unit.
-
In the summer, when this unit is moved from an
air conditioned room to a
hot
and humid place.
-
The unit
is
used
in
a humid place.
• Do not use this unit when there's
the
possibility
of
moisture condensation occurring. Doing so
may damage
your
discs and certain parts inside
this unit.
If
condensation does occur, remove all discs and
leave this unit turned
on
for two to three hours. By
this time, the unit will have warmed up and any con-
densation will have evaporated.
This unit contains a semiconductor laser system and is
classified as a "CLASS
1
LASER
PRODUCT" . So,
to
use this model properly, read this Instruction Manual
carefully. In case
of
any trouble,
pl
ease
co
ntact the store
where you purchased the unit.
To prevent being exposed to the laser beam,
do
not try
to open the enclosure.
CAUTION:
CLASS
1M
VISIBLE
AND
INVISIBLE
LASER
RADIATION
WHEN
OPEN.
DO
NOT VIEW
DIRECTLY WITH
OPTICAL INSTRUMENTS.
THIS PRODUCT UTILIZES A
LASER
.
USE
OF
CONTROLS
OR
ADJUSTMENTS
OR
PERFOR-
MANCE
OF
PROCEDURES OTHER
THAN
THOSE
SPECIFIED
HER
EIN MAY RESULT
IN HAZARD-
OUS
RADIATION
EXPOSU
RE.