Owner's Manual

Connecting the
CDC-3.4-Continued
You
can use the following multi-room kits to control the
CDC-3.4 when it's out
of
range
of
the remote controller:
•
Integra Multi-Room System (IR Remote Controller
Extension System)
•
Multiroom
AV
distribution and control systems such
as those made by Niles® and Xantech®.
Notes:
•
Xantech is a registered trademark
of
Xantech Corpo-
raion.
•
Niles is registered trademark
of
Niles Audio Corpora-
tion.
Controlling
the CDC-3.4 When It's
Out
of
Range
If
the CDC-3.4 is located
in
another room, installed in a
cabinet,
or
out
of
range
of
its remote controller, you can
use a commercially available IR receiver to pickup the
remote controller signals and feed them to the CDC-3.4,
as shown below.
IR
receiver
CDC-3.4
Remote controller
Inside
cabinet
• Signal flow
Connect
theIR
receiver to the CDC-3.4 as shown below.
from connecting block
Mlolpl"g
~ble
:!
~
IR
IN
mm@
'---
---'
CDC-3.4
• Signal flow
Controlling
Other Out-of-range
AV
Components
If
another
AV
component is out
of
range
of
its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the CDC-3.4's IR IN, as shown below.
IR
receiver
:::::
IR
--+-
IR
emitter
~
Other
component
Remote controller
.Signal
flow
Connect
theIR
emitter to the CDC-3.4's IR
OUT
,
and
place
theIR
emitter in front
of
the other
AV
component's
remote control sensor (usually located on its front
panel), as shown below. See the instructions supplied
with the
IR
emitter.
Other
component
Remote
control-+-----+t-J
sensor
=
from
connecting block
.J
'- M;o;pl"g
oab"
•
~l
Mil"'"'
mm
E3:..:...--=III..._,
__
•
....:....----J
IR
Emitter
CDC-3.4
-IR
emitter
• Signal flow
Only remote controller signals received
by
the
CDC-3.4's IR IN are fed through to
theIR
OUT.
Signals
picked up by the CDC-3.4's remote control sensor are
not output.
13