Installation Guide

STEP 9: ALL ROOF PANELS

Components Needed

 13” wide “W” roof panel (J)

 #10 x 3/8” sheet metal screw

 Preformed flashing (N)

 Sealant tube & gun

Tools Recommended

FIRST: Slide new roof panel back into hanging

channel and firmly into foam rubber gasket.

Seal panel ends to foam rubber gasket. Align

new roof panel on 12” mark before securing

with #10 x 3/8” sheet metal screw in panel

“valley” at front fascia.

SECOND: Continue installing each 13” wide

“W” roof panel securely and seal generously

at seams.

Repeat with remaining roof panels until 50%

across roof panels are installed.

Secure Post bottom brackets in next step then

complete remaining roof panels.

THIRD: Install preformed flashing into grove

on hanging rail. Position over first and second

panels. Bend tabs down so they fit snug on

surface of roof panel.

Screw flashing to peaks of roof panels using

#10 x 3/8” sheet metal screws. Seal the top of

screw heads.

NOTE: Each panel must align on 12” mark from early steps before securing and moving to

next panel installation. Overall patio cover width may require to secure and seal roof panels

at varying steps due to access.