Installation Guide

Need help with installation? www.homedepot.com/services/pergola-installation/
STEP 10: SECURE POSTS
Components Needed
 Square Posts (H)
 Bottom Post Brackets (I)
 3/8” x 2-3/4” anchors
Tools Recommended
FIRST: Attach square post at ground to
secure assembly.
Each post must be plumb in all directions.
Mark bottom post bracket position on slab
at desired location for pre-drilled holes.
SECOND: Using the pre-drilled holes in
bottom bracket as a guide, mark both holes
on the slab or surface.
Drill 3/8” diameter holes in slab or surface
with masonry bit (not included) and fasten
bottom post bracket to slab with two 3/8” x 2-
3/4” wedge anchors.
THIRD: Insert wedge anchors and hammer
down each bolt and tighten with 3/8” wrench.
Repeat this step for each post location across
entire assembly.
NOTE: Keep post secured to ladder with ropes until all post are secure into slab or surface.